How to deal with the visual dispensing problem when the automatic visual dispensing machine operates? There are two types of hardware and software in the device. The framework and function of these two types of parts are relatively complex. In the operation stage, if you don't pay attention to them, many problems will appear. The customers who operate the device need to master their solutions when there are many simple problems, so that they can In the operation stage, we should deal with it immediately to prevent the operation of the equipment from being affected by many small problems. Many problems of this kind of production equipment are more and more simple due to the negligence of material operation.

 

Large automatic visual dispensing machine

 

The first visual dispensing problem that is likely to occur in the visual dispensing machine: during the gluing stage, it is found that there is a lack of internal pressure, which is likely to be caused by too much pressure, resulting in many bubbles. The most common reason for this is that after the last operation, there are a lot of residual glue on the internal surface that is not cleaned up. In addition, the next operation may lead to the occurrence of a lot of bubbles In this case, it is necessary to discard and clean all the glue poured into the plastic barrel. In addition, it is necessary to clean up all the remaining glue that has been produced in the past few days. It is necessary to do a good job of the remaining glue that has not been dried. In this way, the glue can be applied again, and it is difficult to have bubbles that may not produce the problem of visual dispensing.

 

Test of desktop type visual dispensing machine

 

There is also a problem of visual dispensing that needs attention. It is caused by the mismatching of needle tubes under the condition of glue application. There will be different types of needle tubes. Before operation, select the combined needle tubes so that you can The third visual dispensing problem in the operation stage is that the glue application efficiency is relatively slow, which is likely to be caused by the high and low pressure. Therefore, it is necessary to adjust the pressure of the pressure equipment. The important role of the adjustment is to reduce the pressure of the colloid in it, so that the colloid can be balanced under the balanced pressure all the time.